The letters L, R, C (Left, Right, Center) represent the position of the runway parallel to other runways as viewed by an approaching aircraft. So 24-18=6 therefore the opposite end will be runway 6. The opposite heading is obtained by adding or subtracting 18,Īnd if below add. Next we'll do the runway numbers, which are between 0-360 (which makes a circle) and the numbers are the heading of the runway divided by 10 so a runway with a heading 240 will be runway 24. It is made up of 4 arrows without lines along the bottom of the threshold, then (depending on how long the displaced threshold is) white arrows with a long disconnected tail along the centerline. A displaced threshold is commonly used at airports where approaching planes must clear an obstacle at the end of the runway, planes don't land on a displaced threshold since it is not stregnthend for such, but planes are able to takeoff and roll out on a displaced threshold. In this guide I will show how to make a realistic threshold (end of the runway) and a displaced threshold. This is where things get kind of complicated, but this should be much easier to understand than the complex aviation jargon used in FAA guidelines. I then use Ploppable Asphalt with these settings to fill the gap.

I use move it to copy and paste this at the endof the black tarmac on each runway. Using the white lines provided I create 2 24m sets of eight lines with a space in the middle. Threshold markings indicate the end of a runway and the number of vertical lines indicate the width of a runway I'm using Vasimr22's airport markings and will be using most of his props in this guide.

Cities skylines default airport